Maniac Line - Foam Gun Pre Wash 4500ML

Foam Gun Prewash from the Maniac Line™ from Mafra is a powerful and safe dry foam cleaner for foam guns, for use in the prewash phase. It respects previously applied protective equipment, even nanotechnology-based protective equipment or coatings.

When used in combination with a high-pressure cleaner, this product can remove 90% of dirt, preventing swirls or micro-scratches in subsequent washing stages.

INSTRUCTIONS:
is recommended for use with a foam gun but can also be used as an excellent pre-wash with a low-pressure hand pump:
- With Foam Gun:
In winter, dilute to 1:5 (1 part product to 5 parts water)
In summer, dilute to 1:10 (1 part product to 10 parts water)
Apply a thick layer of foam to the vehicle;
Allow the product to work on the surface and wait until the foam begins to subside (this can take up to 5 minutes);
Rinse the vehicle from top to bottom.

- With a low pressure hand pump:
In winter, dilute 1:50 (1 part product to 50 parts water) 2 caps in 1 liter of water.
In summer, dilute 1:100 (1 part product to 100 parts water) 1 cap in 1 liter of water.
Apply the product to the vehicle
Allow the product to work on the surface for a minute without letting it dry on the bodywork;
Rinse the vehicle from top to bottom.

RECOMMENDATIONS:

Make sure the vehicle is cool and the car is in the shade, avoiding direct sun.
Rinse the vehicle in the summer to cool the surface or to remove the first bit of dirt.
The product must be dosed from bottom to top. In hot weather, work with one panel at a time to prevent the product from drying on the surface.

You can spray the product directly on the bodywork without wetting it first, even on very stubborn dirt such as mosquitoes and the lower parts of the car, which are always the dirtiest.

If there is mud on the vehicle, remove it with water before applying the product.